🔘 Fastronix Heavy Duty Momentary Start Switch with Neoprene Cap Review

Good quality and construction, standard switch, nothing special. A plus point for me was the grub screws on the ends of the clamps, which makes assembly very easy. If you don't want or need the hype, this switch is perfect.

I was looking for a solid, redundant push button and this was perfect for all my needs. I like that it has an (optional) protective security frame. Another version that combines a protective frame and a weatherproof cover would be great.

I have a '71 FJ40 with a 3 speed shift system. This model uses a steering column mounted reverse gear switch that is activated when the steering column selector is in the reverse position. The old switch was defective. This switch clicked perfectly with no modifications. This must remain so for another 50 years, since the current load is very low compared to the starter.

I used this starter switch on my 1994 Sea-Doo XP. This is a start switch up to 60 AMP. The spring pressure in the key contacts and screws is amazing. This is a very good quality starter. I am sure it will never let me down and I will never have to replace it again. i love good things Greetings George

I bought this switch for my son's drive wheels to replace the foot switch. I've used 2 cheaper switches before and they only lasted a couple of hours each. This switch got heavier once I got my hands on it. It's been about 2 weeks now and seems to be holding up well so far. A little slip to fit behind the original pedal and it worked great.

This is a durable push button switch. I had to replace the old one on my tractor. Because of the screen around the button, this switch is much better than the factory installed switch. It seems more durable and better built than the factory. I'm not sure how waterproof it is, but that's not what I was looking for. It is very easy to install and after a few hundred hours of operation in dirty conditions this switch has never failed.

The Briggs and Stratton auto start feature on my 3000psi pressure washer has stopped working. I'm recovering from shoulder surgery so I have to rely on starting the engine. I bypassed the original wiring to the starter and installed a Legacy Motorsports Heavy Duty Fastronix Momentary Push Button Start Switch (Neoprene Cap) wired directly between the 12v, 25 amp battery and the starter. Now the engine starts at the touch of a button. I've run the engine a couple of times with no issues with the…

The switch looks and feels solid. Installed it yesterday in a new Toy Hauler with Power Canopy. Issue: From the factory, the on/off rocker switch that cycles the power canopy was on all the time. I do not want it; too risky that the canopy could be deployed at any time. Solution: Set this momentary push switch as "on switch" to turn on the rocker switch. The awning now requires two fingers to extend or extend again. (Both switches are installed side by side on the same panel). When I step away,

Installation was successful. This is a simple device. It wasn't clear if the hex nut should be on the front or back of the panel I installed it on. I put the nut on the outside so it attaches to the switch behind the panel. The rubber tip unscrews and is part of a round nut. I guess you could leave it there if you don't need weather protection. However, if you want the switch to be weatherproof, you'll need to install one. However, you cannot tighten it unless you use pliers that crush the…