Lifegard Aquatics Double Threaded Bulkhead Review

Most people who buy these for drainage in their aquaponic beds buy large 1" baffles, but I bought the 1/2" baffle because I already had the materials on hand. Since I wanted to use 1/2" tubing for my plumbing and bus pans for my beds, I didn't need more than 1/2" tubing. I have already added a baffle to the bus tanks and installed a bell siphon, as you can see in the photos. I have already tested the drainage system for the tub beds and it worked perfectly as it could drain the tub faster than…

. The fault was mine. I usually put an o-ring in the tank. After ordering more gaskets to fit the gasket on both sides, I started searching online to see if the side of the gasket with the raised lines goes to the flange or the surface to be sealed (no luck, random side of flange ). with smooth side seal) read that the seal always goes to the flange, not the nut side. Now I have inner and outer seals and it's airtight. I'm not sure if it was the second seal or the one on the flange side, but…

I'm giving it 5 stars for now because I don't see any reason why it shouldn't work for me. Most importantly, here are many of the critical aspects that you may be wondering about. I'm a mechanical engineer and I'm used to a supplier informing me extensively before I buy something, which leads to disappointment in my personal life too often. The product consists of body, sealing washer and nut. Body overall length 1.70", flange diameter 1.80". The flange is 0.21 inch thick. The male thread is 1…