Spartan Power Battery Multimeter 6 5V 100VDC Review

The unit is a bit difficult to set up but I called support. Wow - that's an American phone number and an American support person. I had to wait a little bit, but he was great. Walked me through the menus, set it up and took the time to assist me once I had everything set up. The device works as advertised. This allows me to track the amps and watts being used by my AGM battery and track the current voltage with the % meter in the center of the screen.

I used a gray plastic wall switch housing to place the shunt. I used a dremel tool to open up the side to place the shunt and used zip ties to secure it. I mounted this box to the wall very near the connector where the negative load terminals connect with a #2 wire about six inches long. The battery wire on the other side is about a foot long. Then I used 2 two core cables with red and black wires. I used two black wires for the terminals connected to the shunt side on the battery side and one…

He does what he says. The problem is where you install/install the shunt. I used it to install a solar panel on a caravan. battery in front. I had to install this in the front where there is no cover and protect it from water. The solution I came up with is something like this. ) Electric mastic tapes to cover the screw/bolt (to prevent it from touching the shunt) The shunt is about 4 and 1/2 inches. Just go to your local hardware store and do this: https://www.amazon…