🔩 Vibrant (1167) 3-Inch Stainless Steel Exhaust Seal Clamp Review

I love these clamps. They can be switched on and off many times (unlike the old U clamps). I recommend cutting a slit in the tube near the end to further deform the metal for a nice fit with less abuse on the yoke itself.

I bought these clamps to mount two Flowmaster 15317 3.50" rounded stainless steel exhaust tips on a 2000 Mustang GT. These clamps worked great, I was able to position the clamp screw on top so it didn't The clamps have enough pressure to properly attach the tailpipes to the tailpipes without over-tightening, I can't see them, no ugly welds, and I can remove the tips later if needed.

If you need an exhaust clamp this is the one for you. Stainless steel will last a lot longer than cheap parts stores. They clamp very securely and the hose can be easily removed if needed which is another downside of cheap offerings which tend to kink the hose making removal difficult.

Ich habe diese Schellen gekauft, um 2 Flowmaster 15317 3,50" Edelstahl-Endrohre mit abgerundeten Enden an einem 2000er Mustang GT anzubringen. Эти хомуты работали отлично, я смог расположить зажим болт сверху, так что его не видно.Хомутов достаточно, чтобы правильно прикрепить выхлопные наконечники к выхлопным трубам без чрезмерной затяжки.Не вижу их, никаких уродливых сварных швов, и я могу снять наконечники позже, если es ist notwendig.

This clamp was used to mount a 3" OD exhaust pipe into a 3" ID stainless steel muffler. It worked very well. Remember that for this type of clamp to work best, the outer tube must be cut about 3/4 inch deep at least in places where the clamp can make a good, tight connection. These band clamps are great if you ever need to disassemble your exhaust system as they will not permanently deform components. If your outer tube isn't slotted and you don't have the necessary tools, it's probably better…

This is a great option when you need a strong clip that won't deform your exhaust pipe. Regular exhaust clamps work fine, but if tightened enough to seal, they warp the pipes and make it impossible to separate the tunes in the future. These clips avoid this problem. However, they must have a slit in the outer tube that allows the outer tube to pinch the inner tube. In my application, I simply cut two slots with a portable band saw. Sawzall or a hacksaw will also work. This is a good build and…