🔊 Enhance Your Car Audio Experience with Metra Electronics 825606 Front 6"x9" Speaker Plate (Pair) Review

Needed to install Pioneer's new D-Series 6x9 component speakers into the existing holes on my 2016 F-150 front doors. Works great and keeps the speaker nice and snug on the door.

I bought these for my 2015 Ford F150 XLT along with a Pioneer TS-A6986R and they fit perfectly. Installation took just a few minutes and even the Pioneer speaker holes matched perfectly. I highly recommend it.

Perfect for my truck. I wanted to build something but I'm very glad I ordered and serviced it. I also ordered a wiring harness. I would give 5 stars if the wire holes on the side of this mount matched the plastic wire harness clamp better. Overall a good product.

I think they fit the door but not my JBLs. They don't provide you with screws to attach the speaker to the adapter, which forced me to use zip ties. Although they fit the door perfectly. This is in my 2015 f150. This is probably my fault so make sure your speaker is compatible.

All holes are correctly aligned, supplied screws are creepy and don't grip the adapter well. The screw holes of the speaker and the adapter in the adapter are too big to screw in properly, you will clean the holes. - Get better/wider props or hope the speakers you get come with the right hardware.

This bracket is perfect for the factory truck speakers and the Pioneer AS speakers I installed fit perfectly in the mounting holes. I would give this 5 stars but the included screws didn't work to attach the speaker to the bracket and I had to pull some screws from the tool kit big enough to cut into the screw holes. This will get the job done, but be prepared to do a little digging for the hardware you need.

So the mount for the back of the truck was perfect except you had to drill holes for the wiring. It actually has a hole in it, which is great, but the mounting screws for the speaker itself are too long to use the clip-on mounts that come with many speakers. I ended up flattening the clips so the screws could go into something substantial because I wouldn't trust the speaker's plastic holes lying around. The front fits the truck perfectly, as does the rear, but I think they could use an…