Review on Nimbus Mount Co TNM1 The by Shah Bell

Installation tip: screw the ball firmly into the shifter, then install the bracket and tighten the plastic ring with your fingers, then use the entire bracket to evenly screw the ball more tightly onto the shifter . Loosen the ring on the mount, position as desired, and then remove. This got me almost two extra spins on the ball, eliminating the "wobble" I had from the mount mentioned in other reviews. However, the fastening ring broke after about 4 months (split on one side, completely broken in half when trying to repair with plastic glue). Found these replacement rings in the electronics section of a large grocery store. They're not as "big" as the original, but they work and are only $1 instead of having to buy the whole mount all over again. In addition, the metal plate attached to the case completely blocks the possibility of wireless communication. the charger because it can't be moved far enough (without blocking my phone's camera and placing it so low that the phone "gets heavy on top" and risks the phone's weight causing it that it slips or detaches).