Review on 🔎 ESUN 1.75mm 3D Printer Filament Spool - Optimize Your Search by Matt Kim

I haven't printed much with it, just a few simple test prints. Overall, however, it was very easy to get started. I even printed without a case just to see how it goes. No problem. My only issue is that I started a little low just to see how low I could get away (first time with ASA) but quickly realized I needed to crank it up a bit. After that, the prints came out fantastic. The .2 layer lines were very subtle and only a few protrusions had minor issues but overall everything looked fine and I don't know if I'm the only one but didn't notice much smoke? In any case, I will definitely buy again. My only downside would be that the price seems a bit high compared to other threads available.