Review on Inflatable boat Intex Mariner 3 (68373) gray by Felicja Warno ᠌

The boat was taken recently, they have not even been launched into the water yet. But I would like to clarify it, because each of the sellers has inaccuracies in the description, sometimes even different . So: 1) Declared length 297cm and width 127cm match. But the diameter of the cylinders is 46 (! ) cm no. The diameter of the sides is 34cm, the stern and bow are 35cm. Internal cockpit width ~57-58cm, length ~225-227cm. Where did they get the diameter of the balloon 46cm is not clear. Unless, of course, from an inflated keel to crap for a fishing rod, they didn’t measure it :). 2) Weight. Who writes 25kg, who 35kg . In short - the weight of the bag (by the way, a bag made of non-woven material with impregnation, weighs a maximum of 200g) with a boat, inflatable seats, floorboards, oars, a pump - ~ 30kg + -300g. thirty! By the way, oar collet connectors are a very weak point. s internal aluminum. inserts are needed. While everything. Maybe I'll add it later. ate 07.05202222: Well, it doesn't hold up well on the water. The oars, as I wanted, were reinforced with internal alum. inserts (collets left) - now you can row without fear of breaking the oars :). Rezvenno so goes with 180kg load. Anchor needed! The wind blows. I lubricated the plastic oarlocks with silicone grease - I got a vile creak, and they will last longer. By the way, it is better to keep payolas (bottom) in a separate bag, because they weigh almost like a boat - it is easier to carry / store and you do not need to press the boat so that everything fits into one bag. The boat is assembled / inflated, slowly, in 8-10 minutes. It is convenient to carry by the handles. Protection on the keel by the way - it’s not scary to drag one boat ashore. On the floorboards, despite the fact that they are transversely type-setting, you can confidently stand and throw a spinning rod (if the vestibular apparatus is in order ; ) ). While everything.