Review on Cooktop Tempered Electric Thermocouple Protection by Kendriece Figueroa

I installed propane nozzles and the flame seemed perfect even without adjusting the flow. Instructions show you how to adjust the flame and a small screwdriver is included! The instructions are well written. ATTENTION; The instructions do not specify the required distance from the panel to the tailgate. They tell you to use material around the stove that can withstand 200 degrees Fahrenheit. With the large burner in the back, you only have about 4.5 inches from the center of the large burner to the back of the stove. If your counter is only 21 or 22 inches deep, the backburner will likely burn off the counter splatter when used at full flame! Even with a 23 inch deep rack I don't think I would use it with a large rear burner as pictured in the manual. Personally I would place the stove with the handles to the side parallel to the counter with the large burner in front - with the handles to the side of the back wall. Not perfect, but usable. Incidentally, the same seller sells the same version of SS cheaper elsewhere on Revain. NEWEST - Additional installation fittings may be required! Unit is supplied with a 3/8 male straight fitting and a rubber hose elbow fitting (as shown in the picture). which comes with 4 extra legs that allow it to be used as a freestanding stove. The 3/8" male straight fitting included in the kit goes straight back to the end of the oven opposite the end of the handle. For most meter depths there is no room to attach flexible metal hose and make a 90 degree bend either way. For a permanent installation you will most likely need a 3/8 female fitting - see pictures. 3/8 thread to 3/8 x 3 male / 8 elbow fittings only. In the end I settled on one of these, plus a straight 3/8 female connector and a straight 1/2 male connector to match my existing flexible metal hose connection.