Header banner
Revain logoHome Page
Alex Gilbert photo
1 Level
767 Review
52 Karma

Review on πŸ”§ Black Ten Factory MG21103 Dana Axle by Alex Gilbert

Revainrating 5 out of 5

Easy install, keeps everything on axles

Installed these in my Dana 30 axles for my 2004 lj. The bearing covers wore out after 225,000 miles, and after changing hubs and pulling axle shafts to check and swap out my hearts, I had all the work of installing them. I cleaned as much dirt and rust as I could from the inside of my tubes and installed the outer gaskets (just pushed them into the tubes). The shafts just came back (the inner seals are less likely to rupture) and I filled them with grease and then did the rest of the necessary work with the rest of my jeep. Another tip: be sure to buy a pair of Zerk connector rubber boots because for some reason companies never ship them when they sell things with Zerk connectors. The hardest part of the installation was waiting 2 days for Amazon to ship it to me.

Pros
  • Free for educational purposes
Cons
  • Some cons