Review on 🔍 Black Covercraft LeBra Custom Front End Cover 55508-01 for Select Ford Mustang Models by Scott Gafur

I bought this LeBra front boot for my '97 Mustang convertible to replace my old LeBra front boot that was a bit torn from road debris. Having had an old Lebra front cover for over seven years, I knew only the LeBra cover would fit. The new front cover is identical to my old one which means it's built to last. When I saw the photos on Revain I thought that maybe LeBra no longer uses a mesh screen in the long front opening. It's not like this. Installing the LeBra front cover takes less than an hour. The easiest way to install this front cover on a Mustang is to loosen the parking lights and then push them out a bit. Start at the top and work your way to the sides and down. The front end cover consists of two parts. The front main end cap is held in place by sewn-on pockets that slide over the fenders and center panel under the hood, as well as plastic clips that attach to the body skin. The wheel well clips can be a little tricky to install, but if you turn the wheel inside out they should be a little easier to install. You'll have to pull hard to attach the clips, but don't worry, the clips are a lot stronger than they look. In the seven years I've had my old LeBra front cover, I've never had a clip break. The hood is pulled over the hood and fixed with three straps. The plastic buckles and hooks are stronger than they look. I am completely satisfied with my new LeBra front cover. It is designed to last for many years and fits like a glove.