Review on Horiznext Degree Stainless Street Fittings by Brent Webb
It leaked to me on pipe fittings
I applied two turns of PTFE tape and the inside was leaking. I disassembled and installed three turns of teflon tape. Still leaked. So I removed the elbow and there were no leaks. The elbow I received was too low with female NPT threads. Since the NPT is a V-thread, this means it has been cut too large and is therefore leaking. Now I have a paper weight of 90 degrees.
- High marks for support and durability from testers
- Some bugs
New products
Comments (0)
Top products in π§ Fittings
Upgrade Your Draft Beer Kegerator With The TerraBloom CO2 Keg Pressure Regulator - Dual Gauge Heavy Duty Unit With Safety Features
16 Review
12V Brass Solenoid Valve, 3/4" Electric Air Valve For Water, Air, Gas, Fuel And Oil - Normally Closed By Beduan
10 Review
Joywayus 5/8" ID Hose Barb Hex Union Brass Fitting Water/Fuel/Air With 10 Stainless Steel Clamps (Pack Of 5)
13 Review
High-Quality QiiMii Stainless Steel Sanitary Clamp With Silicone Gasket - 2 Inch, Single Pin Tri Clover Design
16 Review
