Review on 360° Phone and Tablet Stand Holder by Cody Siger

I bought this iPad stand with low expectations as I have bought similar products in the past and they all failed in one way or another. I broke them, broke the hinges and lost the buttons which came loose rendering these previous items useless. Well, I'm happy to report that this one may be the one to rule them all. Immediately after opening the package, I was greeted with about 6 different parts, each of which took about 5 minutes to assemble. The instructions were relatively clear, but once you put a few pieces together the logic kicks in. The clamp on this one is exceptionally strong, and while I didn't press the clamp too hard against the table, it never showed any signs of breaking. or be destroyed. You need to make sure all the parts are tight and secure before you pinch it because if you pinch it and the other parts are loose then it won't be secure in those places. I tried to attach my iPad with case to the holder. Unfortunately the case was too thick and only 1/4 inch wider than the holder. Without the case, it held the holder without any problems. Also tried it with my Nintendo Switch (see picture) which fits very well. and very safe. I can definitely use this for some basic handheld games without a mount. I could also put my phone in it, but that goes without saying as it can hold a lot of large devices. It folds easily for storage later, which I appreciate as I don't have much storage space otherwise. It's quite thick and muscular, which is good as it should hold a few pounds if stretched for long periods of time. what it can do I'm just grateful that I can stop looking for another holder mount.