Review on 🖨️ ELEGOO UV Curing Standard Photopolymer Printing: High Performance for Precise 3D Printing! by Robert Prix

To be honest this is the only resin I've used. I've started doing this since I bought an Elegoo brand 3D printer and counted with the first few bottles. I would use their brand just to be on the safe side. Since then I have continued to buy this particular resin. The choice of colors is great, so far I've used grey, white, black and bright red and they all turned out great. I've had very few bad runs on my prints and they may not have been resin related. The reasons I only bought this resin are as follows, the faint smell is barely noticeable to me, 90% IPA actually smells MUCH more noticeable than resin and as I use this one in my rec room at home it matters a lot to me, well , actually to my wife, but that's the main thing. ; ] - The price is neither the lowest nor the highest, so I think it's fair value. - The print results were really great, I'll add some photos to the review. - I think I got a good thing off, so why bother with it. The only thing I've noticed about this resin so far is this: - It's very important to check the exposure time for the resin before printing, some of the darker colors take more seconds per layer. - White resin sometimes has visible layer lines in the final print. You can't feel or see them when you paint, but if it's just bare resin they're sometimes visible. You need light to heal if you live in a place where you don't have enough sunlight. I'm in the Pacific Northwest and left an imprint on my windowsill for a week that still hasn't fully healed. But under UV light on a turntable, most prints are ready in 5-6 minutes. If I experience anything different or start getting different results I will update this review.