Review on π© Kingston KMBVM Brass Valve F-F by Fred Meeks
Good replacement for ball valve
The valve worked well and was easy to install. I had to wrap the threads with teflon tape 4 full turns to finally get a tight seal with no leaks. The lever turns easily, not too hard and not too loose. I used it to replace a burned dump valve on my 2 year old 5 gallon California Airtools supercharger. The valve seems to be well made.
- NPT female and male threads to connect male port to female port
- Not sure
New products
Comments (0)
Top products in π§ Fittings
High-Quality QiiMii Stainless Steel Sanitary Clamp With Silicone Gasket - 2 Inch, Single Pin Tri Clover Design
16 Review
Joywayus 5/8" ID Hose Barb Hex Union Brass Fitting Water/Fuel/Air With 10 Stainless Steel Clamps (Pack Of 5)
13 Review
DIGITEN DC 12V 1/4" Inlet Feed Water Solenoid Valve Quick Connect N/C Normally Closed No Water Pressure
14 Review
12V Brass Solenoid Valve, 3/4" Electric Air Valve For Water, Air, Gas, Fuel And Oil - Normally Closed By Beduan
10 Review
