Review on ❄️ Kolpin Universal Snow Plow Blade Flap - 10-0190 72 in: Effective Protective Shield for Enhanced Snow Plowing by Craig Sethuraman

I bought this to use with my 72 inch Cycle Country blade that I use with my 14 RZR 800 S and I am very happy with its performance. High quality rubber which I think is reinforced with fabric to increase its durability, similar to duct tape. It does an excellent job of helping the blade roll the snow, preventing spatter and, depending on your speed, preventing the snow from falling back in your face. recommend buying this product for your plow, whether it's on a 4 wheeler, side by side, or in a UTV cab, it sure makes plowing easier. Actual sign dimensions (LxWxH) 72" x 6" x 1/4" There are 11 pre-drilled holes 7" apart starting 1" from the edge. So if you take your tape measure and start on the left (or right none plays roller), there is a hole of about 1", 8", 15", 22", 29", 36", 43", 50", 57", 64 " and 71". If I had to complain about anything, it would be bad instructions. It doesn't take a rocket scientist to figure out how to drill a few holes, but the instructions don't say exactly where to put the valve. I thought you would mount it on a ledge on top of the plow blade, but since the instructions didn't say I had to check it out with a quick google search, and of course I was right Pros: Keeps snow where you want it , not going where you can't - Easy to install - Comes with nylon lock nuts - Durable - Versatile on any sheet 72" or less. Minuses. Not for me at the moment, but if you use side markers you may need one Drill/cut rubber flap to accommodate, see photos Bring out your curiosity or don't have many tools at home, this project requires ;) Squeeze the clamps or a friend to hold them in place and the Markers Pro Tip: Get a metal punch or get a set of these as they come in very handy when drilling through metal Use the punch to make an indentation en the center of each of the marks you made for drill sites. without deforming the metal around it to create a bottom for the drill. I can't express how many times I've had my metal drill bits, here's a cheap set to order with a valve if you don't already have one. 3 in 1 1/32" 1/16" 3/32" Piercing Tip for Metalwork /in/under the hole you just drilled to prevent rust.