Review on π§ Optimized Degree Schedule Barbed Spears for Hydraulics, Pneumatics & Plumbing by Bill Schlag
A sharp 90 degree bend works best for fittings
It would be nice if the bend had a shallower radius instead of a tight 90 degree bend, creating more resistance to liquids, which move around the bend but there is a good surface to grip the hose and the fittings are round so NO filing or sanding was required to remove mold on the serrations.
- Pipe fittings
- Not as thick as other picks
New products
Comments (0)
Top products in π§ Fittings
Joywayus 5/8" ID Hose Barb Hex Union Brass Fitting Water/Fuel/Air With 10 Stainless Steel Clamps (Pack Of 5)
13 Review
12V Brass Solenoid Valve, 3/4" Electric Air Valve For Water, Air, Gas, Fuel And Oil - Normally Closed By Beduan
10 Review
DIGITEN DC 12V 1/4" Inlet Feed Water Solenoid Valve Quick Connect N/C Normally Closed No Water Pressure
14 Review
High-Quality QiiMii Stainless Steel Sanitary Clamp With Silicone Gasket - 2 Inch, Single Pin Tri Clover Design
16 Review
