Review on ๐ Stainless Steel Horizontal Fitting Coupler Connector by Scott Spoja
Stem diameter is smaller than usual
The fittings appear to be of good quality but the end of the stem slipped very easily into the 1" black plastic tube and I was unable to tighten the clamps enough , so as not to lick. I ended up using a regular 1" steel fitting instead, which took some effort to get into the pipe - which is fine.
- Hydraulics, Pneumatics and Plumbing
- I'll write later
New products
Comments (0)
Top products in ๐ง Fittings
1 Inch Beduan Brass Electric Solenoid Valve, 12V Normally Closed Air Valve For Water, Gas, Fuel, And Oil
10 Review
DIGITEN DC 12V 1/4" Inlet Feed Water Solenoid Valve Quick Connect N/C Normally Closed No Water Pressure
14 Review
High-Quality QiiMii Stainless Steel Sanitary Clamp With Silicone Gasket - 2 Inch, Single Pin Tri Clover Design
16 Review
6 Pack Miahart Adjustable 304 Stainless Steel 4 Inch Hose Clamp Duct 91Mm-114Mm Worm Gear Pipe Clamp For Automotive, Mechanical Agriculture.
18 Review
