Review on π Raspberry Pi 3/Pi 2/Model B+/Model A+ Prototyping Shield by TinySine by Isaac Tutt
Barely ok Electronics
This would be a great board, not just normal, if it had mounting holes, and if the connector was flush mounted with the pins sticking out on the other side so you could clip them in on the other side Boards. Anyway, the header sticks down too much because it wasn't flush mounted.
- Wide Range
- Weight
New products
Comments (0)
Top products in π₯οΈ. Single Board Computers
Vilros Raspberry Pi 4 4GB Complete Starter Kit - Black Fan-Cooled Aluminum Case for Heavy-Duty Performance
12 Review
π Ultimate BBC Micro bit Sensor Starter Kit: Keyestudio 37-in-1 Box with Tutorial, Compatible with V1.5 & V2, Gift for Kids and Adults (Microbit Board Not Included)
11 Review
GeeekPi Raspberry Pi Cluster Case with Cooling Fan and Heatsink for Pi 4 Model B, 3 Model B+ & 3/2 Model B
11 Review
π MCIGICM 2 Channel DC 5V Relay Module: Optocoupler Low Level Trigger Expansion Board for Arduino UNO R3, DSP, ARM, PIC, AVR, STM32, Raspberry Pi
11 Review
Another interesting products
M.2 Screw Kit: Easy Mounting for NVMe SSDs on ASUS Motherboards
19 Review
36-Pack Black Rubber PC CPU/Case Fan Screws/Rivets Set for Computer
11 Review
Comprehensive 500pcs Laptop Screw Kit Set for π© IBM HP Dell Lenovo Samsung Sony Toshiba Gateway Acer
12 Review
MacBook Retina 13-inch (A1425, A1502) and π© 15-inch (A1398) Bottom Case Screw Set with Pentalobe Screwdriver
11 Review