Review on Elf Star U Shape Glass Table Edge Protectors: Premium Foam Bumper Guard, High Density, Baby Safety - 2X2 M (13 FT) Black by Sarah Richards

We put them on our glass coffee table on Thursday. So far our 10 months hasn't grappled with it and chewed it up. I'm happy with the protection it offers. Installation was easy, but no instructions were included. Therefore, first clean the table thoroughly.2. Wrap it around the bumper to see where you should put the tape as you want it to be covered. Then remove the bumper and apply tape around the entire edge at the top and bottom. We had enough to make it on our 4x2.3 table. Remove the paper from the adhesive and attach the bumper one side at a time. You have to trim it and there are no corner pieces. So roll it out and have someone hold it on one side while you flatten it to the opposite end. The bumper must be tight. Cutting is easiest with an X-acto knife or utility knife as you can get a clean cut without having to remove the bumper like you would with scissors. Split the corner in half to cover the corner. See photo of the cut - not perfectly clean but it suits us.4. Press and hold the bumper for at least 30 seconds to fix the adhesive.5. Repeat steps 3-4 for the remaining sides. This check does not take into account the deletion and is only valid for three days. If anything changes I will add!