Among all the other "points" that I had a chance to put - there were almost never any problems with these. here they write: - "points need a computer to work, without it they die after a reboot" - this is nonsense! A computer with a controller is needed to install settings and ate. - "a lot of marriage" - nonsense! (put about a hundred, did not meet marriage) - "work only as an" access point "" - not only, there is also a repeater mode. but in fact it is special equipment. and a hodgepodge is not needed here. I personally take it only because it is a good "access point" and it's good that there are no other functions there. - "change the firmware" - also in my opinion nonsense! the firmware is taken and ated from the controller. although if you wish, you can probably change anything . the question is whether this is necessary. those who write that the points are not stable, lose the network on devices, often break, etc. - just crooked under-adjusters. your reasons are elsewhere. (google help you)
🔌 StarTech.com NETRS232 Serial to IP Ethernet Device Server - DIN Rail Mountable - Serial Device Server - Serial Over IP Device Server (Black)
4 Review
🔌 uni USB C Hub with Ethernet Adapter, 4K HDMI, Gigabit Ethernet, and 3 USB 3.0 Ports for MacBook Pro, iPad Pro, XPS
11 Review
HB-UMLS Sabrent USB 2.0 Hub with 4 Ports and LED Power Switches for Each Port
12 Review
🌐 StarTech.com NETRS2321P: 1-Port RS232 to Ethernet IP Converter, Serial over IP Device Server - Black
5 Review