If you are installing an oil pressure sensor on a GM 2.4L Twin Cam engine and want to keep it Factory sensor, then it works perfectly. You will need another adapter to fit the aftermarket sensor into the top port of this unit. Put teflon tape on all threads and use an 18mm wrench to turn the square part of the block. Tilt the top connector toward the power steering pump to disconnect the ignition module connector.
1 Inch Beduan Brass Electric Solenoid Valve, 12V Normally Closed Air Valve For Water, Gas, Fuel, And Oil
10 Review
Vacuum cleaner Dreame V9 Global, white
145 Review
6 Pack Miahart Adjustable 304 Stainless Steel 4 Inch Hose Clamp Duct 91Mm-114Mm Worm Gear Pipe Clamp For Automotive, Mechanical Agriculture.
18 Review
High-Quality QiiMii Stainless Steel Sanitary Clamp With Silicone Gasket - 2 Inch, Single Pin Tri Clover Design
16 Review