Review on π© YDS Stainless Steel Worm Drive Hose Clamp with Adjustable Diameter Bandwidth by Andy Jolley
Range not quite accurate
YDS Stainless Steel Hose Clamps 1/2" to 1" are high quality hose clamps. They can take a good amount of torque without slipping. However, the 1/2" size can be a little oversized. I used it on a 5/8" hose and the yoke was as small as possible and I had to twist it hard to keep it from leaking. If it a 1/2" hose would be I don't think it would still be round and might not work. For 1/2" I would recommend a 1/4 - 5/8" clamp.
- Industrial & Scientific
- Skimpy Instructions
New products
Comments (0)
Top products in π§ Fittings
High-Quality QiiMii Stainless Steel Sanitary Clamp With Silicone Gasket - 2 Inch, Single Pin Tri Clover Design
16 Review
12V Brass Solenoid Valve, 3/4" Electric Air Valve For Water, Air, Gas, Fuel And Oil - Normally Closed By Beduan
10 Review
Upgrade Your Draft Beer Kegerator With The TerraBloom CO2 Keg Pressure Regulator - Dual Gauge Heavy Duty Unit With Safety Features
16 Review
Vacuum cleaner Dreame V9 Global, white
145 Review
