Review on 🖨️ Optimized Filament 1.75mm Printing Material for Printers by Cameron Reed

Compared to other PLA filaments, this filament required some fine tuning to print properly. I suspect it has to do with some kind of haze-inducing additive. Adhesion was the biggest issue for both the printing platform and itself. It didn't flow as well as other PLAs, had to increase the hot end temperature a bit and raise the extrusion multiplier a lot before it produced objects that wouldn't fall apart. Do some test prints to adjust the settings before using it to print anything large. Recommended for aesthetic or lightweight objects, avoid anything that requires structural strength.