Review on Geeetech Filament: Enhancing Dimensional Accuracy for Printers by Chris Castro

Filament worked great but if something happens the printer has to pause on site and in the case for a while Than the Temperatures dropped below 27 degrees, the filament broke about 2 inches from the extruder so it was easy to pull the drawer out, but I wasted quite a bit of filament doing this, so I stopped after noticing this about 2 or 3 times when that case falls below 30°C, this will never happen again. Always at least one printer in the case that prints the job, in my cases there are multiple printers. 2 in one and 3 in the other. but that solved this problem. the same was true for black and white threads. both printed excellently but were very brittle at lower temperatures. but I will buy it again because it is known, works and is relatively cheap.