The boards LOOK identical including the screen printing on the board but either the DIP switch is wired differently or both boards I purchased have, they are defective. The WeMos switches work as shown in the attached photo; I have 3 of these and they work great. If I set the HiLetgo 5, 6 and 7 DIP switches, I can boot the ESP8266 firmware, but I can't find the combination of switch settings that will allow me to boot into the Mega. With each setting, Windows 10 Pro reports that the device is not recognized. Now it's possible that the switches on this board are wired differently, but it's impossible to know since HiLetgo doesn't provide any documentation or answer the question I posted here. I also searched their website (hiletgo.com) and could not find any information on this product. I recommend stopping by. As a result, this board is useless.
GeeekPi Raspberry Pi Cluster Case with Cooling Fan and Heatsink for Pi 4 Model B, 3 Model B+ & 3/2 Model B
11 Review
🌐 MCIGICM 2 Channel DC 5V Relay Module: Optocoupler Low Level Trigger Expansion Board for Arduino UNO R3, DSP, ARM, PIC, AVR, STM32, Raspberry Pi
11 Review
🎁 Ultimate BBC Micro bit Sensor Starter Kit: Keyestudio 37-in-1 Box with Tutorial, Compatible with V1.5 & V2, Gift for Kids and Adults (Microbit Board Not Included)
11 Review
Gikfun Screw Shield Expansion Board: Enhance Arduino UNO R3 with the EK7007 Add-On
11 Review
M.2 Screw Kit: Easy Mounting for NVMe SSDs on ASUS Motherboards
19 Review
🖥️ Helifouner 450-Piece Computer Standoffs Spacer Screws Kit: Ideal for Hard Drive, Motherboard, Fan, Power Graphics & Computer Cases
10 Review
Comprehensive 500pcs Laptop Screw Kit Set for 🔩 IBM HP Dell Lenovo Samsung Sony Toshiba Gateway Acer
12 Review
MacBook Retina 13-inch (A1425, A1502) and 🔩 15-inch (A1398) Bottom Case Screw Set with Pentalobe Screwdriver
11 Review