Header banner
Revain logoHome Page
Andy Sayloon photo
1 Level
511 Review
0 Karma

Review on 🌱 Mold Star 15 Silicone Rubber for Slow Moldmaking - Trial Unit by Andy Sayloon

Revainrating 5 out of 5

Remove Bubbles

Follow Instructions. Stir all ingredients before using. After measuring, stir well and mix until a uniform color is obtained. All of this mixing causes a lot of air to get into the product, which eventually shows up as a poor finish. Use some kind of trough when pouring material. Pour the mixture down the shaft slowly and don't use an angle that is too steep. Don't pour a lot of material at once. The trough and slow movement down to the mold vat allow time for the bubbles to dissipate. Some material will be lost in this process, but the results will be much better. Additionally, lining the feeder with parchment paper will make cleaning the feeder much easier. Nothing sticks to parchment paper. I like to use the wrapping paper tube.

Pros
  • Regular Price
Cons
  • Available in White Only