Review on 📏 Revolutionary Milwaukee Magnetic Wide Blade Measure: Boosting Precision and Efficiency in Measurements by Jose Mcdaniel

If you need to measure a 2"x4" board for cutting, good luck. The tab on the end does not stay on the end of the board. The ribbon is bent leaving less than 1/8 inch to catch on the end of the board. The only way to counteract the slipping is to tape a piece of metal to the end of the board and then the magnet will hold the tape. Otherwise you should get another tape measure Also the range is less than 7ft wall so no one is holding the end of the tape or you can tape a piece of metal to the side wall and it will stay This is not good tape for carpentry I would do not recommend it to anyone who uses it primarily for work on wood.