Review on 🔊 CQRobot Speaker 3W 4 Ohm: Perfectly Compatible with Arduino Motherboard & JST-PH2.0 Interface, Ideal for Small Electronic Projects by Timothy Richmond

Name: 🔊 CQRobot Speaker 3W 4 Ohm: Perfectly Compatible with Arduino Motherboard & JST-PH2.0 Interface, Ideal for Small Electronic Projects
Item: 🔊 CQRobot Speaker 3W 4 Ohm: Perfectly Compatible with Arduino Motherboard & JST-PH2.0 Interface, Ideal for Small Electronic Projects
Rating: 4

November 07, 2022

Not the worst, but not the best either

For $8 (and two speakers) it's not that bad, just don't expect them to get richer. their level of quality, and just know how much you're spending on these two speakers. If you understand this, these speakers will not cause you any problems. They are very easy to use, just connect them to your amp and you're done.

Pros

Don't waste too much time

Cons

Not bad, but...

New products

Comments (0)

Please, sign in to write a comment

Top products in 🖥️. Single Board Computers

🌐 MCIGICM 2 Channel DC 5V Relay Module: Optocoupler Low Level Trigger Expansion Board for Arduino UNO R3, DSP, ARM, PIC, AVR, STM32, Raspberry Pi

2.81

11 Review

Gikfun Screw Shield Expansion Board: Enhance Arduino UNO R3 with the EK7007 Add-On

3.27

11 Review

🎁 Ultimate BBC Micro bit Sensor Starter Kit: Keyestudio 37-in-1 Box with Tutorial, Compatible with V1.5 & V2, Gift for Kids and Adults (Microbit Board Not Included)