This is a simple 1/2 in. male/female NPT brass elbow. What can go wrong? It looks like there's a lot of copper in brass, which is a good thing. The male end screwed directly into the female fitting, but the male tube did not screw into the female end. Upon closer inspection, the NPT tap did not penetrate the fitting far enough for the exposed threads to accept the male fitting. I've tried various male fittings and none of them caught the threads. It was part of a muffler system for the intake of a piston air compressor. I ended up using an internal thread rat tail file and made the hole a little larger. Then, with a lot of pushing and turning, the male fitting finally snapped into the threads and was tightened with a pipe wrench. A lot of fuss for a simple elbow.
12V Brass Solenoid Valve, 3/4" Electric Air Valve For Water, Air, Gas, Fuel And Oil - Normally Closed By Beduan
10 Review
High-Quality QiiMii Stainless Steel Sanitary Clamp With Silicone Gasket - 2 Inch, Single Pin Tri Clover Design
16 Review
Upgrade Your Draft Beer Kegerator With The TerraBloom CO2 Keg Pressure Regulator - Dual Gauge Heavy Duty Unit With Safety Features
16 Review
6 Pack Miahart Adjustable 304 Stainless Steel 4 Inch Hose Clamp Duct 91Mm-114Mm Worm Gear Pipe Clamp For Automotive, Mechanical Agriculture.
18 Review