Review on 🔆 JDM ASTAR Projector LED Fog Light Bulbs H11 H16 - Bright White PX Chips for Enhanced Visibility by Robert Ewing

For those of you who aren't sci-fi fans or fans but rather pedants, the title would imply that you are as intelligent as our current President in a parallel but mirrored universe, in which up is down, black is white, and overwhelming stupidity is supergenius. Why do I use comparisons like this when I KNOW that not everyone will "understand" them? Sigh. Okay, review: They're bright. I mean, "I could probably just drive at this brightness if my main set of LED headlights went out." Simple plug and play technology and you don't have to do excessive disassembly to to get to her. [Below is the procedure for a 2015 Honda Fit. While other fasteners may be similar, if you don't have the same Generation Fit as a 15, watch YouTube videos on how to build your specific car.] Starting at the wheel well, remove the screws and plastic studs. " to the centerline of the wheel arch. Then look under it and there's probably a screw or two and two or three plastic fasteners. If you break them, go back in time and get a box of different sizes from that very one Page. Please DO NOT go to the parts table at your dealership as these little bugs are priced on your car. RECEIVE A PACKAGE OF PLASTIC FITTINGS. Um, anyway, once you've followed the edge where the plastic grille with the Chassis is connected and removed When you are done with the fasteners, you can slide the plastic cover aside and put your hand in the running lamp holder, grasp the base of the lamp, rotate it counterclockwise about 90 degrees, and the lamp should come out of the housing. If you are wearing a headlamp and you can see what you are doing, you need to press down on the small clip that holds the cord attached to the bulb, and then pull out the bulb. It's locked there, so don't pull it. d Pressure on the clamp and a slight wobble releases the lamp. Installation is the reverse order. Once you've wired it up and locked it in the case, make sure everything works before screwing everything back together. Repeat on the opposite side. It took me about 10 minutes per side, but again, I'm fairly familiar with the underside of the Fit.