Header banner
Revain logoHome Page
Ada Jadczak ᠌ photo
1 Level
173 Review
0 Karma

Review on Accumulative combined water heater Thermex Combi Inox IRP 280 V (combi) by Ada Jadczak ᠌

Revainrating 3 out of 5

Not everything is so bad, but there are disadvantages.

I took a boiler in MirCli. Now initiated the process of exchanging goods for a new one. Took the boiler in early September. It's the beginning of November now. Let's see how they work on the exchange of goods. 05/27/2022. 3 months after the initiation of the replacement of the tank, a new one was brought. Termex did not want to agree on a replacement for a long time. As a result, we gave up and we replaced it with the same tank so as not to redo the eyeliner. But the eyeliner did not fit everywhere, because the axes of the new Termex are either even or shifted to the other side than the previous one. So if the eyeliner is iron and hard, then these tanks are not even interchangeable ! Now the heating element has flowed. The photo shows that it is flowing along the heating element itself. Conclusion: poor build quality. Two problems with different boilers. I do not recommend to anyone. Terrible slow service and warranty service, as if the manufacturer is doing a favor by replacing your product.

img 1 attached to Accumulative combined water heater Thermex Combi Inox IRP 280 V (combi) review by Ada Jadczak ᠌
img 2 attached to Accumulative combined water heater Thermex Combi Inox IRP 280 V (combi) review by Ada Jadczak ᠌
img 3 attached to Accumulative combined water heater Thermex Combi Inox IRP 280 V (combi) review by Ada Jadczak ᠌



Pros
  • - Very successful elongated tank format. Greatly saves space in the boiler room. - The presence of the possibility of a three-phase connection evenly distributes the load on the network. - Possibility to connect/disconnect the heater on each phase separately, which gives a stepwise power adjustment of 2/4/6 kW. - Solid analog temperature and boiler power controller in electric mode. - Beautifully decorated exits for connecting pipelines.
Cons
  • - 3 outlets for connecting pipelines are directed in different directions. I was lucky that I use PP pipes, due to which I relatively easily leveled this problem. But it would be impossible to connect an iron pipeline in this way - the misalignment of the axes and the divergence are 7-10 degrees. - The coil is leaking. The pressure in the heating system (2 atm - antifreeze), when the boiler coil circuit is connected, increases due to the leakage of the coil. Water from the boiler (4 atm) slowly flows into the heating system and raises the pressure to 3 atm in an hour and a half, after which the boiler safety group is activated. - a regular pressure fuse of very low quality: the casting is thin and crooked, when used in the operating mode it makes noise - something in it vibrates strongly. It is not critical for the boiler room, but if placed in a quiet room, the noise will bother you. The manufacturer's instructions do not allow you to install any other fuse than the standard one.