I used this adapter to attach a 3M tension wheel adapter (5/8 - 11 thread) to my bench grinder with an M14 thread. The threads are fine, but the internal threads were poorly finished and had tons of shavings inside that I had to strip and clean. Then when I snap on the 3M adapter and expansion wheel, I find that this adapter is misaligned. I could literally see the wheel spinning from the center and it shook my entire table. Then I put nothing but the Toolocity adapter on the sander mandrel and checked the alignment by putting on an Allen wrench and vibrating it. This adapter may be suitable if you want to mount an angle grinder on a bench grinder where the wheel is closer to the actual grinder motor and shaft. But for a tool that attaches to it and further from the grinder, like the expander wheel and 3M adapter, it will likely increase that adapter's misalignment and have too much vibration. I plan to use this adapter with angle grinder cutting discs and those that abut against the adapter body and are not dependent on adapter male thread orientation. That should work.
Bonvoisin Hydraulic Hand Pump Manual Ram Pump 8500Psi Porta Power Pump For Hydraulic Tools(CP-180)
4 Review
Sim Sensitive System 4 Spray therapeutic Chitosan Hair Repair "R", 50 g, 50 ml, spray
7 Review
CEKER ISO A 5675 AG Pioneer Style Male Female Hydraulic Quick Disconnects Dust Cap Plug Covers Fittings With Retention Ring Red 3/4
8 Review
Nokian Tires Hakkapeliitta 9 SUV 225/55 R18 102T winter
6 Review
Upgrade Your Draft Beer Kegerator With The TerraBloom CO2 Keg Pressure Regulator - Dual Gauge Heavy Duty Unit With Safety Features
16 Review
Joywayus 5/8" ID Hose Barb Hex Union Brass Fitting Water/Fuel/Air With 10 Stainless Steel Clamps (Pack Of 5)
13 Review
High-Quality QiiMii Stainless Steel Sanitary Clamp With Silicone Gasket - 2 Inch, Single Pin Tri Clover Design
16 Review
DIGITEN DC 12V 1/4" Inlet Feed Water Solenoid Valve Quick Connect N/C Normally Closed No Water Pressure
14 Review