Review on Actuator Cadillac Avalanche Silverado Bonneville by Pete Norris

On initial installation I found that one of the 3 nuts holding the lock in place was turning and would not tighten the T-30 fasteners. By removing it and then using a hammer as an anvil and hitting another on the other side I was able to fix it. (The second photo shows the position on the old part). After the second install I found that the orange connector for holding the rod from the external key lock was too big to hold securely. The stalk just falls off. I took it off again... I took a piece of the old latch assembly and used it even though it's 15 years old. After two repairs, the new bolt finally works! Not as smooth as OEM but acceptable.