Review on 🔫 Review: Blaster Nerf Elite Disruptor B9837 - Unleash Extreme Dart Power by Boguslawa Bieda ᠌

From experience, the drum is the best multi-charge option. We play with the whole company with small ones. 6 rounds is optimal. If more, then it is cumbersome, if less, then there are not enough bullets. The drum is simple. It is not a reclining drum, but like a Disruptor. It can be recharged at any time. And this is a huge advantage over clips - with their long reloading, weakness for the size of bullets, distortions, etc. Even if the enemy has several clips, they will end sooner or later and while reloading - complete helplessness. Plus wedged bullets in the store and again helplessness. With a drum, this is simply not possible. The drum has run out - you can shoot one bullet at a time. If you have time, charge as much as you can. Shoots pretty well. If cocked with the trigger clamped, then a shot will occur. So this is how you can shoot a burst! The design of the mechanism is quite simple, it is possible to refine it. The fact is that the bullets are deformed and no longer sit so tightly in the barrel / drum. The spring force of the safety mechanism is enough to push them out. It is treated by removing this mechanism nafig as unnecessary. It works like this - when the bullet is loaded, it presses on the flag of a spring-loaded plate. This plate closes the holes through which the air is pushed out by the piston. This mechanism, apparently, is designed to force you to buy only original bullets (because others will not sit tightly in the barrel and will not shoot). It is necessary to remove this plate with a flag and a spring from the piston. Everything, now you can shoot at least paper balls. But there is also a hole in the piston cylinder. It serves, apparently, in order to bleed the air if they fired without bullets. Now this hole can be safely filled with glue (Moment is just right), which will give a little power. You can also reduce the gap between the piston and the drum. Air is lost through this gap. It is treated by gluing a couple of layers of electrical tape. That's it, now you have a universal six-barreled pistol.