Review on Toyota Genuine Accessories PT398 47110 Remote by Brandon Garrett

Installed this remote start myself. Followed DIY Remote Start on Priushat and it was pretty easy. All of the interior trims came off easily (no need to fiddle with the steering wheel trim for the Gen III Trim II model. You need to insert the harness pin into the existing connector (just make sure it's fully seated) and the rest of it's easy to do with existing wiring harness to align the connectors and finish the final wiring with the zip tie Make sure you mark the hood latch before removing to ensure proper adjustment after you have installed the hood interlock switch I installed the unit, until the instructions required it to force ECU to detect new remote starter (about 2 1/2 hours) I took it to the dealer for the detection part and made sure they had easy access to the 'connectors' (male and female) on the Have bottom plate (approx. 1 hour) works well but is limited by the range of the remote control , about 70-80 feet. The system turns off when you open the door and the alarm The alarm flashes until the engine starts (about 5 seconds). Don't forget the range limiting factor.