Review on 4 Pack 3" Stainless Steel Hose Clamps - 75-90Mm Adjustable Worm Gear Duct Clamp by Cory Miles
A little rough in the inside
Over all they seam to be a sturdy clamp . It has an odd size screw (6MM) in my years of servicing commercial laundry equipment most clamps of this size are either 7mm or 1/4 inch. They are an 8mm band with which is what I needed. I put a magnet to the band, screw, and housing and the whole clamp was non-magnetic which would indicate a good quality stainless steel. The inside of the bands could be finished better. they are a little rough and the "teeth" of the band will dig into the hose .
- Fits good, it does the job and not much else to say. All around solid
- Did what ordered for, but need to back off after 1/4" advance then start again.
New products
Comments (0)
Top products in 🔧 Fittings
Upgrade Your Draft Beer Kegerator With The TerraBloom CO2 Keg Pressure Regulator - Dual Gauge Heavy Duty Unit With Safety Features
16 Review
6 Pack Miahart Adjustable 304 Stainless Steel 4 Inch Hose Clamp Duct 91Mm-114Mm Worm Gear Pipe Clamp For Automotive, Mechanical Agriculture.
18 Review
1 Inch Beduan Brass Electric Solenoid Valve, 12V Normally Closed Air Valve For Water, Gas, Fuel, And Oil
10 Review
12V Brass Solenoid Valve, 3/4" Electric Air Valve For Water, Air, Gas, Fuel And Oil - Normally Closed By Beduan
10 Review
