Review on 🛡️ SimbaLux Clear Plexiglass Protective Sheets for Enhanced Project Safety by Ryan Nguyen

These sheets were purchased to be laser cut/engraved for use in LED night lights (base lights are of course sold separately). Acrylic cuts beautifully using settings from the web as a starting point. The resulting images were clean and of good quality. There is protective paper on both sides of the panels. I left it in place while cutting (to protect the cut edges from possible burns) and then removed the uncut portions of the paper. Large areas of the backing were easily peeled off by hand, then small areas of the paper backing were cleaned with a light (**scratch resistant!**) Scotchbrite/O-Cel-O pad under warm running water. The paper peeled off immediately leaving a scratch free finish and some really nice made to measure gifts. The images shown are approximately 7 inches tall and show the LED illuminating the image. Notice that the edges of the owl image are a bit rough as my software tries to circle the owl multiple times. My fault is how I imported the image, not the fault of the acrylic sheet. The rest was nice and smooth after one pass.