Review on Bac Kitchen Caliper Automotive Suspension Possible by Jon Delgado

The dimensions in the photo appear to be correct. They are nine inches tall when you stand them up straight and measure from the surface to the highest point of the top hook. If you measure from the furthest points of the two hooks at about a 30° angle, it's 9-5/8 inches. Hooks are 3-1/8" wide on the outside and 2-3/4" on the inside. The rod from which they are bent is 3/16 inch in diameter, and 0.2 inch equals 3.2/16 inch. They feel very stiff and should hold when a caliper is hung on them. When I held them and tried to bend them, the metal flexed a little, but it straightened out. The paint has a small bald spot on one end and they come with some extra end caps. If that was such a big problem, it would be possible to get a yellow wrench and completely cover that end. I just want to avoid damaging the brake lines. I received this set to use for another repair if needed. The reason I'm removing the calipers this time is to swap out the rear bearings. The name Bac-Kitchen sounds like they were once pot hangers.