Review on Metal Foot Rest Kick Panel for 2007-2018 Jeep JK Left Side Dead Pedal: Upgrade for Jeep Wrangler & Wrangler Unlimited by Ted Higdem

Item arrived well packaged in protective bubble wrap. It is very well designed and made from high quality steel with a very nice finish. The fit is perfect, which in turn speaks for technical and manufacturing standards. However, as with many products these days, this product again comes with no paperwork! No instructions, no warranty card, no product information, no manufacturer identification or ANYTHING! You open the box and inside is an item wrapped in bubble wrap. That's all. Hello Manufacturer: Since most of you refuse to include installation instructions, how about putting a small piece of paper that says "Thank you for purchasing our product" in the box? Too much to ask? Seems to be. At least with this article, the installation is not difficult. But since the manufacturer doesn't tell you, I will. You need a 10mm socket and in my case I used a short extension to make it easier. When removing the door strap (and wiring harness for later Jeeps), take extra care not to let your door "slam shut" and hit the hood. I decided to leave the door strap attached. Remove the 2 bolts holding the door belt clip in place and remove the 2 nuts from the electrical "ground" bolts in front of the door belt clip. Position the dead pedal so that the two vertical holes line up with the holes in the door strap bracket and then the two "ground" screws line up well with the remaining holes in the dead pedal bracket. Hand tighten the two nuts and the two door belt buckle bolts, use a 10mm socket to tighten securely and you are done. Very easy.