Review on Vetroo MESH6 Gaming Case - 6X ARGB Fans, Mesh Front & Tempered Glass Panel, Mid Tower ATX For Optimal PC Cooling by Isaac Ismail

Wish I had taken photos.This case looks cool BUT there are errors in manufacturing.The motherboard riser holes are in wrong places but can be managed. The screw hole mounts (for the glass sides) are not properly aligned/positioned and makes using the rubber protective grommets unusable. Since the holes are misaligned, the glass gets tensioned/twisted when trying to tighten the screws to install the glass panels. Both sides are incorrect. I had to eliminate the rubber grommets and put the glass against bare steel and ended up needing to actually aggressively twist the entire metal case to get the holes to even lineup just barely enough to put the screws in.once glass is installed, I had to leave the mounting screws loose otherwise tension and breakage of glass would occur.Expert assembly can make this case usable but it's risky.Take note: ONLY use micro-ATX size motherboard because larger boards seem like they're supposed to fit BUT interfere with some water cooling. I had to replace a 2-fan AIO from the top because of this. I resorted to a single-fan AIO in the rear of case and this looked cooler anyhow.All in all the case does look cool and is affordable (likely because of it's bad points).Moving it is very difficult because of nowhere to hold and glass panels are dangerously close to hand holding positions. Extreme care was used to get this to the customers car and I hope they get it to their son's room with no accidents. tolerance for the holes in the glass