Review on Spoilboard Surfacing Cleaning Flattening Woodworking by Travis Vasquez

I make hobby cutting boards and sell quite a few. I recently built a router sled to speed up leveling my end boards and picked up this piece to help me. I took about one dose. boards, and this bit cuts turnaround time by about half an hour per board. I can get it up and running down the line in just minutes and start sanding right away. The bit is sharp and works well in my Bosch 1.5hp router. I will buy it again if he gets bored (although he hasn't shown any signs of it so far). The photo shows the cutting board before it was fed through the router carriage.