Review on 🔌 Dumble Electrical Wire Connector Junction Box 1-Pack for Trailer, Camper, RV Lights 7 Gang/Pole Automotive Wiring Rewiring by Angel Scully

Received a $900.00 quote to repair the tail lights on a 1 ton dump truck. (On Dodge 3500 '94) I decided to fix the problem myself. (I haven't worked with truck wiring since the early 80's) I didn't want to get under my old truck. But I put the bed down, pulled the hell up and got to work. The wiring has been repaired over the years for the trailer hitch wiring, requiring a full body suit. I cut, test and label ea. the cable. (Just behind the gas tank) I routed a 6 wire cable back to the center and installed a dumble junction box. The quality and finish of this plastic junction box was excellent. The 7 clamps were solid and I was able to connect all the ring terminals I needed for my brakes, parking, right and left turn, reverse and parking lights. The box had blank soft rubber inserts allowing me to cut the exact size hole I needed for excellent waterproof penetration. The lid fits very well and is screwed on tightly with a lock. I didn't use sealant on the cap or wire grommets, but I will when I'm done wiring the trailer connector. Nice box for that purpose and I would buy it again. This box allows me easy access to the wires to install the trailer light connector in the future. And I used very little black tape. Very happy about that! (Yes, I used some shrink wrap if needed) Just a suggestion: I'd like the box to be 5/8" longer and 5/8" wider to have extra room around the terminal block. so that the wires are properly stretched. But everything worked fine and such.