Review on 🔨 Powerful Aluminum Can Crusher, Sturdy Pneumatic Cylinder Soda Beer Can Crusher, Sustainable Recycling Tool (Convenient Countertop Button Valve) by Melissa Marie

I am very satisfied with this product. It was the cheapest I found. I bought it on a whim, hoping it would work well and that maybe I would change it to make it better. Setup took less than 5 minutes. (Yes, I needed a 1/4" fitting to connect to my compressor). The cylinder and can holder seem very strong and durable. The more it breaks. The 200mm stroke is equivalent to 7.9 inches, so it fits into almost any aluminum can or bottle. It takes about 30-40 psi to crush a can without denting. At 25 psi the can will hold its shape. At 30 psi it will withstand a small dent, and one large dent will crush the can. Once the can is crushed, it will be crushed to at least 1.5". It has been found to work very well at 60-80psi and will crush cans to less than an inch. At a set pressure between 80-100 it works like a beast and keeps breaking below 3/4". Between 120-130 psi it collapses to about 1/2". For those geeks. If my calculations are correct this will produce the following pounds of force at the following pressures: 26 lbs @ 20 psi, 122 lbs @ 40 psi, 219 lbs @ 60, 315 lbs @ 80 psi, 412 lbs @ 100 psi 40 in min) The only thing that slows you down is the occasional sticky cuz you were going too fast I broke three huge bags of cans in no time and was suddenly frustrated that I ran out of cans to break.