Review on LASFIT H11 H8 H9 LED Bulbs, 6000K Cool White - Hassle-Free Plug and Play Halogen Upgrade - 2Pcs by Tim Hull

(I've uploaded two photos: one shows a new LASFIT H11 bulb for the low beam next to a factory Halogen 9005 high beam; the other shows the wiring harness for the bulb.) The LASFIT H11 was perfect for Lexus ES350 2011 with low beam and easy to install! In fact, the hardest part was keeping the engine cover's plastic clips in place! For this car the process was: 1. Remove the front engine cover, then the two side engine covers (with all the plastic plugs)2. Make sure the bulbs are cold (Halogen and HID bulbs are HOT!).3. The low beam (which is NOT daytime running/high beam) is an external headlight.4. From inside the engine bay, take the plastic bracket (off-white in the picture I uploaded) and turn it counter-clockwise a quarter turn so that it faces the bracket as if you were inside the engine bay (in other words, a regular screw )5 . Remove the lamp and existing bulb from the headlight housing.6. Remove the existing lamp from the bracket.7. Identify the positive and negative terminals on the bracket - mine weren't marked so look at the incoming wires (white for +, black for -). Install the LASFIT lamp with the correct polarity. Put the light aside - only install it after you've tested it.9. Turn on the low beams (these are NOT daytime running lights)10. If it works, install it into the headlight by lining up the slots in the bracket and gently pushing in and turning clockwise (again as viewed from the inside of the engine bay). If that doesn't work, check that the polarity of the lamp matches the fixture. I started without knowing what would be required and in about an hour I had two lamps installed. I was so pleased with the LASFIT low beam that I purchased the 9005 high beam and installed it in about 15 minutes.