Review on 🔩 BestTeam 10PCS T-Slider for T-Slot, M6/M8 T-Track Slider Sliding Nut Aluminum Alloy T Slot Nut for Woodworking Tool Jigs, Screw Slot Fastener (M8) by Justin Ritter

Because manufacturers make their 3/4" angled slots to varying tolerances, there is no one non-adjustable insert that fits all. They work well in most slots, but in most cases they wobble a bit When used in jigs that require clamping, the tops of these pieces stay slightly below the top of the corner guide, which is good.I drilled and re-tapped a couple of them for the larger screws.For some of the corner slots, their tops will be above the table surface when clamped in. I had to file/grind some of them thinner to prevent this.As always, with enough creativity this can be fixed.