Review on 🔒 Enhance Vehicle Security with GANGMU TEC Pack of 2 Universal Aluminum Hood Pins - License Plate Lock, Push Button Bonnet, Quick Release Lock Latch Bumper (Silver, 1.25 inch Diameter) by Steven Ali

My car is a 2004 Acura TL. The TLs are made in Ohio on the same platform as the Accords. I hate to say it, but unlike the TSX, which is made in Japan (called Accord Euro in Japan), the quality control isn't up to par, and there are noticeable gaps between the body and bumpers. The worst section had a gap of up to 1 cm. I needed something to fix the problem without spending $$$ at the auto repair shop. This turned out to be the best solution to fix the problem. On the left and right side of the rear bumper I was able to reduce the gap by more than half (the gaps are still there but much less noticeable). I used a unibit or step drill to drill holes in the PPP bumper. The main thing is to make the hole a little smaller than the ring so they are tight and the nut and Loctite don't come loose. I installed 3 pieces on each side (6 total). Like many other things they are made in China but the quality is not that bad which is why I gave them 4 stars.