Review on Power supply unit AeroCool Aero Bronze 750W black BOX by Stanislaw Biedka ᠌

Name: Power supply unit AeroCool Aero Bronze 750W black BOX
Item: Power supply unit AeroCool Aero Bronze 750W black BOX
Rating: 5

May 13, 2023

Reliable purchase, guaranteed to be a good purchase.

While there is no information about reliability, but the first impression is strictly positive! Oh, and one more thing. Probably so conceived, but the inclusion occurs as if in two stages. I pressed the power button, the standby LEDs on the motherboard instantly light up and only after two seconds the main power is turned on and the fans start. This is the first time I've encountered this behavior. Always before, when the computer was turned off (well, not quite straight from the outlet, but simply turned off), such a "duty" lamp was still on the motherboard, and when the power button was pressed, the valves immediately started. Here it is done differently.

Pros

The block is really good! Before putting it in my main computer, I first checked the block on an old and very demanding hardware! Here on this - Xeon X5670@3.7 1.28V and two HD5870 in cross + HDD. And then on two HD6950s stitched into 6970 (250W TDP for each). 4(8) processor cores were loaded with cpu-z stress, the remaining 2(4) cores were for Stalker and MetroLL games. It’s a pity there is no wattmeter, but I’m sure that at least 100W came from the processor and from video cards (6970s) at least 2x200W + 40 watts mother and HDD. PCIe wires are barely warm, no more than body temperature. At the PSU, the wall where the board is installed also warmed up a little. The air blown out of the PSU (guess the first time) is also a little warm. Unlike hot air from video cards heated under 90C. The fan is very quiet, you can say silent. Although if you bring your ear close, you can hear a low-frequency vibration, but you don’t feel the vibration of the PSU case with your fingers. In idle, the Intel cooler at 1600 rpm and the video turbines at 1300 rpm were noticeably audible, so nothing was heard from the PSU side. The voltage was measured with a multimeter in the Molex. The minimum that I saw was 122022V, the maximum was 12.25V.

Cons

I did not like the design of the 8pin (6 + 2) connectors. The pipets is as tightly mounted and the two-pin tail is removed. I almost cut myself on the plastic . In the old PSU, this tail was just a sideways chpynk and unfastened. It would not be superfluous to sign the connectors.