Review on Dock Edge Wheel Corner Mount by Stephanie Rivera

I can't provide installation information because my marina insists. I'm not sure how they will withstand ultraviolet rays, we'll have to wait for that. Air pressure is applied through a large hard plastic screw. I had to look for a portable air compressor. I think I could take the wheel off and take them to the stationary supercharger (hmm why didn't I think of that sooner). You will need a long, blunt hose (about 3/4 inch) to hold and seal everything while pumping. I had to inflate too much because when you remove the tube the air comes out before you can put the plastic screw in. Be very careful not to lose your grip, otherwise the screw will fly into the water. I would suggest the only improvement is to install a tire valve stem so you can inflate to the exact PSI without worrying. about losing a screw. The manufacturer may have a "screw-in" valve stem to replace the existing bolt. That would be perfect.n