Review on πͺ Enhance Efficiency with Sydien Pneumatic Cylinder Connector MAL16X200: A Reliable Solution by Kenny Hrdlicka
Port sizes too small for this application
It took only a few minutes to realize that anything but very light finger tightening of the M5 connector plugs would cause the o-rings to bulge out instead to seal. There is also not enough room on the M5 threads to use Teflon tape. They only have 2-3 threads to screw into the cylinder. If the cylinder is finger tight and the cylinder is actuated several times it will unscrew the M5 connector from the cylinder rendering it unusable. Do yourself a favor and choose 1/4 or 1/8 NPT cylinders instead.
- Pneumatic
- Only available in black
New products
Comments (0)
Top products in π© Pneumatic Equipment
Another interesting products
Upgrade Your Draft Beer Kegerator With The TerraBloom CO2 Keg Pressure Regulator - Dual Gauge Heavy Duty Unit With Safety Features
16 Review
1 Inch Beduan Brass Electric Solenoid Valve, 12V Normally Closed Air Valve For Water, Gas, Fuel, And Oil
10 Review
Joywayus 5/8" ID Hose Barb Hex Union Brass Fitting Water/Fuel/Air With 10 Stainless Steel Clamps (Pack Of 5)
13 Review
6 Pack Miahart Adjustable 304 Stainless Steel 4 Inch Hose Clamp Duct 91Mm-114Mm Worm Gear Pipe Clamp For Automotive, Mechanical Agriculture.
18 Review